Anybody know how to program a remote for a 2003 Pontiac Montana? - pontiac remote programming
I have a remote control is a 2003 Pontiac Montana, which must be programmed. Someone out there knows how to do it?
Anybody know how to program a remote for a 2003 Pontiac Montana? - pontiac remote programming
I have a remote control is a 2003 Pontiac Montana, which must be programmed. Someone out there knows how to do it?
Copyright 2009 Blow machine scrapbook. Powered by
Blogger.
Blogger Templates created by Deluxe Templates
Wordpress theme by digitalnature
1 comment:
Channel programming
Note: All channels must be recognized by the remote control door lock transmitter (RCDLR) are programmed in a single order. If the system is in program mode, erase all previously programmed stations will receive the programming signal of the first transmitter. Up to four transmitters can be programmed. Do not use or program the transmitters in the vicinity of other vehicles that are on the way to program keyless entry. This prevents the programming of the transmitter in the right vehicle.
1. Remove the ignition key lock cylinder.
2. Remove the fuse prgrm BCM fuse box. See Electrical Center Identification Views in Wiring Systems.
3. Close all doors.
4. Insert the key in the ignition lock cylinder.
5. At 1 seconds, follow these steps: Turn the ignition to ACC, then OFF, and CCA.
6. If only the 1 Step, then the BCM will Feedbaseck, the recent actions are wrong. To program the transmitter should step 5 instead. If step 5 is done right, then flashing the BCM May error codes. In this case relate to the availability of diagnostic system - the Governing Body Control System Control System.
7. Open and close all doors. The campaign BCM confirm that programming mode introduced.
8. Press and hold the channel lock and unlock for about 14 seconds.
Important confirmation: After about 3-5 seconds the BCM Gong again, that the programming was done at the transmitter.
9. Repeat the previous step for each additional channel program.
10. Remove the ignition key lock cylinder.
11. Install the fuse blows prgrm BCM in the backup.
12. In order to exploit each issuer to verify the correct operation of the system.
(For more information, visit 1-800-492-9568. Have Junior in the party.)
Post a Comment